
Preliminary Data Sheet
8GB DDR3 – SDRAM ECC SO-DIMM
Features:
204 Pin ECC SO-UDIMM
Rev.0.9
20.09.2011
SGN08G72G1BB2SA-xxRT
8GB EP3-10600 in FBGA Technology
RoHS compliant
Options:
?
?
?
?
?
?
204-pin 72-bit DDR3 Small Outline, Dual-In-Line Double
Data Rate synchronous DRAM Module
Module organization: dual rank 1024M x 72
V DD = 1.5V ±0.075V, V DDQ 1.5V ±0.075V
1.5V I/O ( SSTL_15 compatible)
Fly-by-bus with termination for C/A & CLK bus
On-board I2C temperature sensor with integrated serial
presence-detect (SPD) EEPROM
?
?
Data Rate / Latency
DDR3 1333 MT/s CL9
DDR3 1066 MT/s CL7
Module density
8GB with 18 dies and 2 rank
Marking
-CC
-BB
?
?
?
Gold-contact pad
This module is fully pin and functional compatible to the
JEDEC EP3-12800 DDR3 SDRAM 72bit-SO-DIMM
design spec. and JEDEC- Standard MO-268. (see
The pcb and all components are manufactured according
to the RoHS compliance specification
?
?
?
Standard Grade
Grade E
Grade W
(T A )
(T c )
(T A )
(T c )
(T A )
(T c )
0°C to 70°C
0°C to 85°C
0°C to 85°C
0°C to 95°C
-40°C to 85°C
-40°C to 95°C
?
?
?
?
[EU Directive 2002/95/EC Restriction of Hazardous
Substances (RoHS)]
DDR3 - SDRAM component Samsung K4B4G0846B
512Mx8 DDR3 SDRAM in PG-TFBGA-78 package
8-bit prefetch architecture
Programmable CAS Latency, CAS Write Latency, Additive
Latency, Burst Length and Burst Type.
Environmental Requirements:
?
On-Die-Termination (ODT) and Dynamic ODT for
improved signal integrity.
?
Operating temperature (ambient)
?
Refresh, Self Refresh and Power Down Modes.
?
Standard Grade
E-Grade
W-Grade
-40°C to 85°C
Operating Humidity
0°C to 70°C
0°C to 85°C
-40°C to 85°C
?
?
ZQ Calibration for output driver and ODT.
System Level Timing Calibration Support via Write
Leveling and Multi Purpose Register (MPR) Read Pattern.
?
10% to 90% relative humidity, noncondensing
Operating Pressure
Figure: mechanical dimensions
1
105 to 69 kPa (up to 10000 ft.)
?
?
?
Storage Temperature
-55°C to 100°C
Storage Humidity
5% to 95% relative humidity, noncondensing
Storage Pressure
if no tolerances specified ± 0.15mm
1682 PSI (up to 5000 ft.) at 50°C
1
Swissbit AG
Industriestrasse 4
CH – 9552 Bronschhofen
Fon: +41 (0) 71 913 03 03
Fax: +41 (0) 71 913 03 15
www.swissbit.com
eMail: info@swissbit.com
Page 1
of 15